Amphenol

HEX454CU0000x

Tri Band, 6-Port, Panel, XPOL, 45°, 696-960 | 1695-2400 | 1695-2400 MHz, 1189 mm.

Antenna · Panel Verified from manufacturer datasheet
Manufacturer PDF Product page

Parent code HEX454CU0000x (batch-5 re-check rank 229): the x is the RET-actuator option in the datasheet ordering table (REV030519NA, p.7) - M manual tilt, G RET with MDCU, L/L1/L2 RET with MDDU (different AISG port configurations). Datasheet recovered from the Wayback Machine snapshot (2021-10-19) of the manufacturer PDF at https://amphenol-antennas.com/datasheets/HEX454CU0000x.pdf; the live file was removed in the 2024 site redesign. F/B printed as '>24 dB' (696-960) and '>27 dB' (1695-2400); USLS as '>18 dB' / '>15 dB' typical; recorded as plain numbers. Gain is the single figure published per sub-band (no separate average). Isolation: in-band >25 dB (696-960), >28 dB (1695-2400); between ports >30 dB. Ports assigned sequentially low to high (low 1-2, high arrays 3-6); the datasheet does not number the RF ports. Mounting bracket kit 36210006 ordered separately.

SPEC.COVCoverage6 band rows
600700850AWSPCSWCS
Band, MHz Ports GainHorizontal BWVertical BWElectrical tilt PIM, dBc Power / port USLS, dB
696–806MHz 1-2 13.8dBi 48° 22° 0–14° -153dBc 500W 18dB
806–960MHz 1-2 15.1dBi 41° 18.2° 0–14° -153dBc 500W 18dB
1695–1850MHz 3-6 16.5dBi 50° 9° 0–10° -153dBc 250W 15dB
1850–1990MHz 3-6 17dBi 45° 8.5° 0–10° -153dBc 250W 15dB
2100–2180MHz 3-6 17.5dBi 43° 7.8° 0–10° -153dBc 250W 15dB
2200–2400MHz 3-6 17.8dBi 41° 6.9° 0–10° -153dBc 250W 15dB
SPEC.VARVariants5 variants

The trailing letter of the model code is the tilt-actuator option, from the datasheet ordering table (REV030519NA, p.7): M = Manual Electrical Tilt (MET); G = Remote Electrical Tilt (RET) with factory-installed MDCU (Multi-Device Control Unit); L, L1 and L2 = RET with factory-installed MDDU (Multi-Device Dual Unit), differing in AISG port configuration. The RF specs are identical for all five variants.

Variant codeWhat differs
HEX454CU0000M Manual Electrical Tilt (MET), tilt knobs at the indicators, low band 0–14°, high bands 0–10°
HEX454CU0000G Remote Electrical Tilt (RET) with factory-installed MDCU (Multi-Device Control Unit), AISG v2.0/3GPP
HEX454CU0000L RET with factory-installed MDDU (Multi-Device Dual Unit); AISG Port A Red (696–960 MHz), Port B Orange/Yellow (1695–2400 MHz)
HEX454CU000L1 RET with factory-installed MDDU; AISG Port A Yellow (1695–2400 MHz), Port B Orange/Red
HEX454CU000L2 RET with factory-installed MDDU; AISG Port A Orange (1695–2400 MHz), Port B Yellow/Red

One antenna, one page — these are ordering options of this model, not separate models. The specs on this page apply to every variant unless the table says otherwise.

SPEC.ELEElectrical
Polarization
±45°
VSWR
1.5: 1
PIM, 3rd order
By band, see Coverage
Max input power
By band, see Coverage(2x) 500 W (696-960), (4x) 250 W (1695-2400); no total figure published.
Impedance
50Ω
Isolation
>25 dB in-band (696-960), >28 dB in-band (1695-2400); >30 dB between ports
SPEC.MECMechanical
Dimensions
1189 x 397 x 187mm
Weight
18.1kgantenna only
Wind load
Front 604 N, side 280 N at 160 km/h
Max wind speed
241 km/h (150 mph)
Connectors
6x 7/16-DIN female, bottom
Port count
6
Mounting
Not published
SPEC.PRTPorts6 total
  • Ports 1-2 696–960MHz
  • Ports 3-6 1695–2400MHz
1+2−3+4−5+6−
Illustrative port layout — drawn from the published 6 ports and ±45° polarization. The arrangement is schematic; the exact positions are in the manufacturer PDF.
  • Ports 1–2696–960MHz
  • Ports 3–61695–2400MHz
SPEC.PATRadiation patterns6 bands
0°90°180°270°HBW 48°
Horizontal — 696–806MHz
0°90°180°270°VBW 22°tilt 0–14°, shown at 7°
Vertical — 696–806MHz

Illustrative patterns — the main lobe is drawn on a 0 to −30 dB scale so its −3 dB width matches the published beamwidth. The back lobe, where shown, sits at the published front-to-back ratio. Sidelobes are not drawn. The exact plots are in the manufacturer PDF.

CALC.EIRPUse this gainEIRP / ERP

Pick a band. The gain comes from the table above. Add your transmit power and feed loss to get EIRP.

EIRP — Turn on JavaScript, or use the calculator link.

EIRP = TX power − loss + gain (dBi). ERP = EIRP − 2.15 dB. Open the full EIRP calculator →

All Amphenol models
SOURCESource and corrections
Source
Manufacturer datasheet PDF, read 2026-11-12: https://amphenol-antennas.com/datasheets/HEX454CU0000x.pdf
Datasheet revision
REV030519NA
Added

Specifications belong to Amphenol and can change without notice. The manufacturer’s current datasheet is the authority; check it before you sign a report. Everything on this page is public data — the same datasheet anyone can find with a Google search. Nothing here is proprietary.

Report an error in these specs

Upload a newer datasheet revision